Hagen Brothers farms,Goodrich ND | I updated my EZ Guide + to the new 4.10 firmware early this spring, but have had a little trouble when using" headlands". If the field border has a lot of direction changes where the outside round may double back on itself, The unit sometimes seems to lose the outside round/rounds so I have to start over again. The last time it happened, the headlands line on the screen was gone and the end one or two led's at both ends of the light bar were flashing. I unplugged the light bar then reconnected to let it reboot and all worked fine. Anyone know what may be happening here.
Also I see that the 4.10 update has changed, at least some of the end numbers/letters in the title have changed. Is this a revised update that I should load on the light bar, like what Farmer Dale talkes about down the page. ? TIA
Edited by Jon Hagen 6/5/2007 14:18
|
EZ Guide + headlands problem ?
