|
| I had ignition problems with my yale forklift with the mazda engine. It would die after running for 15 minutes and eventually it killed the ignitor. Some folks here suggested I check the key switch. It turns out the switch must have been replaced with a close, but not quite switch that was missing a terminal. The previous owners had added a jumper to make up for the missing terminal and apparently this didn't help the ignitor one bit and it killed it eventually. Now with the right switch it's all good now (still needed a new ignitor, but it should last a while). Now I just have to replace a seal in one of the long upright cylinders.
Thanks,
pat | |
|