|
Sutherland, IA | I posted a while back about trying to get my htz rate up higher on our trimble 132 when using it for spraying with direct command. I finally was able to get it to go to 5hz using both the insight to change the settings and i could also do it using agremote. I'm not sure why but i had to unhook the light bar from port B to be able to change it. If i left the lightbar hooked up to the 132 it would only allow me to go as high as 2 hz position rate. Now post spraying should be a little nicer being able to go over 8-9mph but i was just wondering out of curitosity why was i unable to change the htz to no greater than 2 with the lightbar hooked up? | |
|
trimble 132 htz changing
