AgTalk Home
AgTalk Home
Search Forums | Classifieds (66) | Skins | Language
You are logged in as a guest. ( logon | register )

20 spline PTO shaft for 7700, 4430, etc
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
Dennis
Posted 8/5/2006 09:58 (#32881 - in reply to #32669)
Subject: RE: 20 spline PTO shaft for 7700, 4430, etc


I am getting in the same spot. I don't think there is a good way to get to using the big shaft as standard. You can't buy a 12 or 14 series yoke with 1 3/4 spline, right? I suppose they won't make one cause it won't stand the power. Then the product liability of someone putting way more power thru a lite drive line than it will handle. I agree the adapters are a bad answer. On the other hand, the complete shaft assembly with the proper end is brutally expensive if you need 30 - 50 hp.


Sort of like all the different electrical plugs. 240v 20a single phase, 240v 30a 3 phase, 50 amp single phase welder plug, ad infinitum. Things that used to work on 2 wires now take 4, but they are safer so it is good.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)