|
El Campo/Houston, TX | After 24 hours of work finally got off. I ground and cut on it with everything made in this green earth . Heated the spindle , heated the cap , cut out bearings , nothing worked. Borrowed a plasma cutter and started taking chunks out of it till almost melted plasma down. Finally borrowed a mag drill and started drilling on the INSIDE of spindle into the part that threads into spindle . Through many prayers and good luck managed to drill barely touching threads on opposite sides and then cut the remaining web with sawzall with carbide blade . Then started to beat on it for the thousandth time with big cleco air hammer and it started to move . After what seemed like forever it finally spun off. Threads look good .
(IMG_6643 (full).jpeg)
(IMG_6645 (full).jpeg)
(IMG_6647 (full).jpeg)
Attachments ---------------- IMG_6643 (full).jpeg (165KB - 4 downloads) IMG_6645 (full).jpeg (182KB - 2 downloads) IMG_6647 (full).jpeg (178KB - 1 downloads)
| |
|