|
| #1 is for your desired cut height.
#2 is for a secondary cut height such as lifting 4 inches over a rock.
Under toolbox set max head height under header tab. This is what it will lift to on the ends.
When on ends, hold shift button and press resume button at same time, it will lift to set max head height, then tap resume once to return to #1 setting.
I used to use the number 2 as my max head height. Did it that way for 15 years. It’s actually not the way it’s supposed to work. Plus you have to tap resume twice after each time you shut the header off. | |
|
Calibrating bean head
