|
Holly Hill, SC | Assuming that code is gear not fully engaged. Should show a picture of two gears with a diagonal on the small display. If skinny enough, go to right side of transmission and see if the wires are plugged into the rear of the transmission. If you can not fit, just remove the small triangle panel. May need to change sensor. I do like the sensor upgrade on these machines. I have ruined second gear on a 2588 and a 2166 because they where not fully engaged into the gear.
Edited by shulerfarm 9/15/2024 19:05
| |
|
Case Ih 7088 transmission code
