|
s.e. Pa | We have had a 1411 for a long time. The splines have been showing at the top of the drive coupler for as long as I can remember, but I don’t think they should be. I have replaced the 4 pins and bushings that hold the cutter at on before, and with a jack under the cutter bar there is no movement of the coupler on the splines. Is this correct? If not, what could the problem be?
 (IMG_1445 (full).jpeg)
Attachments
----------------
 IMG_1445 (full).jpeg (160KB - 2 downloads)
| |
|
New holland 1411 cutterbar drive splines
