|
Bloomfield MO | Figured it out. After removing from the combine, remove the hydraulic fitting and drain oil. Put the cylinder in a large vise. Push the cylinder ram in, until you see a snap ring, through the hydraulic fitting hole. Rotate the cylinder ram, until you can see the split in the snap ring and pry it forward into the second groove. Pull cylinder ram out.
I just tore the two down that were on the combine and another wore out one, I had. Pretty dam easy job,……… so far. Ya’ll happen to know a part number for a 2388 feederhouse lift cylinder, seal kit?
(IMG_5750 (full).jpeg)
(IMG_5752 (full).jpeg)
(IMG_5753 (full).jpeg)
Attachments ---------------- IMG_5750 (full).jpeg (78KB - 5 downloads) IMG_5752 (full).jpeg (89KB - 4 downloads) IMG_5753 (full).jpeg (93KB - 2 downloads)
| |
|