|
| Having a hell of a time tracking down a set of sprockets to go on a hydraulic motor. I need an inch and a half bore with a 3/8 key with either a 8 or 9 tooth sprocket in 80 chain. Google isn’t my friend this time around.
I can get those numbers with an X series hub but with 12tooth minimum and that’s to much. Any ideas where to check? Scouring the county side all this past weekend
 (IMG_1202 (full).jpeg)
Attachments
----------------
 IMG_1202 (full).jpeg (136KB - 42 downloads)
| |
|
Shot in the dark. Weld on Sprocket question.
